How To

How to Wash a Fishing Reel: 5 Mistakes That Shorten Its Life and the Right Way, per Shimano and Daiwa

Hands holding a spinning reel after fishing
minagiman

Do you rinse your reel under hot water when you get home? That may actually be shortening its life. Based on Shimano’s instruction manuals and Daiwa’s official guidance, here are the washing mistakes to avoid and the right routine. It only takes five minutes.

The most common reel problems are a gritty feel, heavy winding and a handle knob that will not turn. Most come from salt or sand left behind, or from washing the wrong way and flushing out the grease inside.

Five ways NOT to wash a reel

1. Washing with hot water

It seems hot water would remove salt better, but it does the opposite. Shimano’s manual clearly says not to use warm water because it may wash out the grease. That grease protects the gears, so always use cold fresh water.

2. Washing with the drag loose

With a loose drag, water gets into the drag washers inside the spool. Both Shimano and Daiwa say to tighten the drag before washing.

3. Dunking it in a bucket

Submerging the reel lets water in through the gaps. Shimano’s manual warns against submerging the reel body. Just rinse it briefly under a shower.

4. Drying with a hair dryer or in the sun

Shimano advises against hair dryers and direct sunlight because they trap humidity inside. Dry it in a shady, airy place.

5. Too much grease or oil, or in the wrong place

More is not better. Be especially careful with the roller clutch (the anti-reverse part) and the inside of the rotor. Grease there can stop the anti-reverse working and let the handle spin backwards.

MistakeWhat happens
Hot waterGrease washes out, causing gear wear and a gritty feel
Loose dragWater gets into the drag; drag becomes inconsistent
SubmergingWater gets inside; bearings and gears rust
Hair dryer or sunHumidity gets trapped inside
Too much greaseAnti-reverse may stop working

The right way: five steps

  • 1. Remove it from the rod: water collects between the reel foot and reel seat and causes corrosion
  • 2. Tighten the drag firmly: keeps water out of the drag
  • 3. Rinse with a cold fresh-water shower: wash off salt, sand and dirt. No hot water, no dunking
  • 4. Remove water, loosen the drag and dry in the shade: towel off and keep out of direct sun
  • 5. Oil once dry: a small amount only where the manual says, such as the line roller

Daiwa’s beginner guidance says to tighten the drag on a spinning reel and pour water from the drag side: spool up, water flowing from top to bottom. Strong spray from below makes it easier for water to get into the body. Low pressure is fine; the aim is to dissolve and wash away salt, and one or two minutes is enough.

Where and how often to oil

Shimano’s manual (for the 21 Nexave) gives this guide:

ItemDetail
WhenAfter washing and drying
How oftenOnce every five trips, and once if your next trip is more than a month away
How muchAbout one second of spray
Oil pointsLine roller, main shaft (base of the shaft with the spool off) and others
Grease pointsHandle shaft, moving parts of the arm cam
UseThe maker’s own oil and grease

The part that suffers most at sea is the line roller. Wet line constantly runs over it, and if it seizes it causes tangles and line twist. If it feels sticky, check here first.

Where NOT to oil

  • Roller clutch (anti-reverse): grease may stop it working
  • Inside the rotor: do not spray grease
  • Drag: only the maker’s own drag grease
  • Water-resistant seals: some models have no-oil areas; always check your manual

Reels differ in construction, so always check your own manual. Shimano publishes manual PDFs on its support site.

Shimano and Daiwa maintenance products

Use the same maker’s products as your reel; Shimano’s manual says it cannot guarantee quality with non-genuine products.

ShimanoDaiwa
Standard productReel Maintenance Spray (oil and grease set)Reel Guard Spray Set (oil and grease)
ForShimano reelsDaiwa reels

Troubleshooting

Sand in the reel on the surf

If you put the reel on the sand and it now grinds when you wind, do not keep winding: sand gets into the gears and bearings and spreads the damage. Rinse off surface sand with fresh water first. If the grinding stays, sand is probably inside, so send it for an overhaul. Better still, use a rod stand so the reel never touches sand.

Dropped in the sea

If it was hit by a wave or dropped in, wash it in fresh water as soon as you get home and dry it well in the shade. If winding feels off, get it overhauled soon; rust spreads inside over time.

Knob will not turn or the reel feels gritty

A handle knob or line roller that will not turn is often salt build-up. Daiwa notes that seawater causes rust and salt seizure that can stop the knob turning. If washing does not fix it, the bearing needs replacing.

Storage

  • Store the reel off the rod
  • Keep it in a dry, cool place
  • Do not leave it wet in the car boot or on the dashboard
  • Loosen the drag if you will not use it for a while

Leaving tackle in the car after fishing is the most common mistake. A hot, humid car is the worst place for a reel.

Wash rods and small gear too

Daiwa advises rinsing rods, wiping them dry and drying them in the shade, using a mild detergent on very dirty areas. Salt builds up at the base of the guides, so pay attention there. Just rinsing lures and pliers with fresh water and drying them makes a huge difference to rust.

My take: how you wash matters more than how much you paid

A reel’s lifespan is decided by the five minutes after you fish, not by its price. A ¥10,000 reel washed properly every time will run well for years; even a Stella left unwashed can feel heavy within a season. The surf, with salt, sand and spray, is the harshest place for a reel, so make “tighten drag, rinse cold, dry in shade, oil lightly” a habit. If it starts to feel wrong, do not take it apart yourself; send it for an overhaul. Tip: wash the reel before you clean the fish, and you will never forget.

Summary

  • No hot water, no dunking, no hair dryer
  • Tighten the drag before washing and rinse from above with cold fresh water
  • Towel off, loosen the drag and dry in the shade
  • Oil about once every five trips, mainly the line roller, a little at a time
  • Never grease the roller clutch or inside the rotor; check your manual
  • If something feels wrong, stop using it and get an overhaul

Related: drag setting guide.

ABOUT ME
MINAGIMAN
MINAGIMAN
JAPAN ANGLER
Born in 1994. Originally from Hyogo Prefecture, I moved to Iwata City in Shizuoka Prefecture in search of the sea. I am an Enshunada surf angler who enjoys surf fishing. I am also active on YouTube, and my fishing grounds range from Irago to Iwata.
記事URLをコピーしました